Mold Removal/Burbank, CA
Where the new roof
meets the old one.
Almost every house here has been added to. The junction between the old roof and the new one is where the inspection begins.
A free mold inspection in Burbank
Most Burbank houses have been added to at least once. The junctions between what was there and what came later are where the inspection starts.
Why Burbank houses grow mold
Burbank’s housing is largely post-war tract and studio-era bungalows, and the defining characteristic is that very few of them are still the house that was built. Bedrooms added at the back, garages converted, patios enclosed, second stories put on. Each of those is a reasonable project and each one created a junction.
Junctions are where buildings leak. A new roof plane meeting an old one needs flashing that is easy to do adequately and hard to do well, and a saddle or a valley created by an addition concentrates water that previously ran off freely. Twenty years later the flashing is the oldest part of the newest work, and the staining shows up on a ceiling below it.
The other legacy is the ventilation. An addition frequently extended a roof over what used to be a vented eave, blocked a gable vent, or created an attic section that connects poorly to the original one. Air that used to move through the assembly now has a dead end, and the dead end is usually the part above the newer rooms.
What an inspection checks first in Burbank
First stops on a Burbank property
- Every roof junction where an addition meets the original structure, from inside the attic
- Valleys and saddles created by a later roof plane
- Attic sections over additions, and whether they connect to the original attic’s ventilation
- Converted garages and enclosed patios, which rarely got the original house’s detailing
- Bath and kitchen extraction in the added rooms specifically
The newest work fails first
It is counter-intuitive and it is consistent. The original 1940s roof has had eighty years to prove itself; the 2004 addition has had twenty, and its flashing is the youngest detail on the building.
When the staining is over a newer room, the inspection starts at the junction rather than working outward from the stain.
Neighborhoods this comes up in most: Magnolia Park, Rancho, Toluca Woods. The method does not change by address; what the inspector expects to find does.
Ask when that part was added.
It is the first question on a Burbank inspection and it saves more time than any instrument. Owners nearly always know, often to the year, and the answer points straight at the junction, the flashing and the piece of attic that was created along with the room. A house that has never been extended is genuinely rare here, and it is a different conversation when it happens.
Mold removal questions Burbank owners ask
Frequently, yes. Flashing at a junction between two roof planes is the hardest detail on a residential roof to get permanently right, and twenty years is long enough for a marginal one to start admitting water during heavy rain. The attic tells you quickly, from underneath.
Because a junction leak often admits a small volume during storms only, into an attic where it lands on sheathing and dries slowly. Nothing ever drips onto a ceiling, nothing ever stains visibly downstairs, and the growth develops above it over several winters.
It is one of the most common, and it comes down to detailing: a slab poured for a car, walls that may not be insulated, and often a laundry added later. It is usually straightforward to treat and worth checking even when the complaint is elsewhere.
If the source is a junction or flashing, yes, and the findings will say which detail rather than just recommending a roofer generally. Treating the attic without closing the junction is the version of this job that comes back.
Book a free inspection in Burbank
Burbank is about twenty minutes out. If you know roughly when the addition went on, say so.
What happens next
An inspector walks the property, most often Noel or Eddie, the two their customers name in review after review.
Written findings with the moisture source named, and no obligation attached to them.